Search results
Results from the WOW.Com Content Network
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels .
Some solid substances that are not minerals have been assigned a hardness on the Mohs scale. Hardness may be difficult to determine, or may be misleading or meaningless, if a material is a mixture of two or more substances; for example, some sources have assigned a Mohs hardness of 6 or 7 to granite but it is a rock made of several minerals ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
Very hard steel (e.g. chisels, quality knife blades): HRC 55–66 (Hardened High Speed Carbon and Tool Steels such as M2, W2, O1, CPM-M4, and D2, as well as many of the newer powder metallurgy Stainless Steels such as CPM-S30V, CPM-154, ZDP-189. There are alloys that hold a HRC upwards 68-70, such as the Hitachi developed HAP72.
1095, a popular high-carbon steel for knives; it is harder but more brittle than lower-carbon steels such as 1055, 1060, 1070, and 1080. It has a carbon content of 0.90-1.03% [7] Many older pocket knives and kitchen knives were made of 1095. With a good heat treat, the high carbon 1095 and O-1 tool steels can make excellent knives.
The first scientific attempt to quantify materials by scratch tests was by mineralogist Friedrich Mohs in 1812 (see Mohs scale). [3] [4] The Mohs scale is based on relative scratch hardness of different materials; with talc assigned a value of 1 and diamond assigned a value of 10. [5] Mohs's scale had two limitations: it was not linear, and ...
The Mohs scale of mineral hardness; The Vickers hardness test; The Brinell scale; The Janka hardness test; The Rockwell scale; The Durometer scale; The Barcol scale;
When testing coatings, scratch hardness refers to the force necessary to cut through the film to the substrate. The most common test is Mohs scale, which is used in mineralogy. One tool to make this measurement is the sclerometer. Another tool used to make these tests is the pocket hardness tester. This tool consists of a scale arm with ...