Search results
Results from the WOW.Com Content Network
68HC11 block diagram. Internally, the HC11 instruction set is backward compatible with the 6800 and features the addition of a Y index register. [a] It has two eight-bit accumulators, A and B, two sixteen-bit index registers, X and Y, a condition code register, a 16-bit stack pointer, and a program counter.
MDC (Motorola Data Communications), also known as Stat-Alert, MDC-1200 and MDC-600, is a Motorola two-way radio low-speed data system using audio frequency shift keying, (AFSK). MDC-600 uses a 600 baud data rate. MDC-1200 uses a 1,200 baud data rate. Systems employ either one of the two baud rates.
A Motorola T-1300 series remote control is built in a telephone housing. The telephone dial is replaced with a metal plate on which is mounted a speaker, volume control and option switches. This remote control uses a two-wire circuit to control a base station. A General Electric MASTR II remote control and desk microphone.
Pairing mechanisms changed significantly with the introduction of Secure Simple Pairing in Bluetooth v2.1. The following summarizes the pairing mechanisms: Legacy pairing: This is the only method available in Bluetooth v2.0 and before. Each device must enter a PIN code; pairing is only successful if both devices enter the same PIN code. Any 16 ...
In 2012, Binatone became a global licensee of Motorola, [3] producing audio equipment, GPS devices, dash cams, and other electronics under the brand. [ 4 ] [ 5 ] [ 6 ] Lalvani is the CEO of the internet-of-things company Hubble Connected, which develops wireless products for Motorola .
MIKBUG was part of the extensive M6800 microcomputer support developed by Motorola's Application Engineering Group. MIKBUG is a ROM monitor from Motorola for the Motorola 6800 8-bit microprocessor. It is intended to "be used to debug and evaluate a user's program". [1] MIKBUG was distributed by Motorola in 1974 [2] on a 1 K ROM chip part number ...
A second display or second displays is a common term describing the multi-monitor setup with just one additional monitor attached. Today it is particularly common to have one workstation with two monitors connected where the second monitor is referred to as the second display. Many tablets will serve as a second display connected to a laptop. [22]
The Wide Field Camera 3 (WFC3) is the Hubble Space Telescope's last and most technologically advanced instrument to take images in the visible spectrum. It was installed as a replacement for the Wide Field and Planetary Camera 2 during the first spacewalk of Space Shuttle mission STS-125 (Hubble Space Telescope Servicing Mission 4) on May 14, 2009.