enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cylinder head porting - Wikipedia

   en.wikipedia.org/wiki/Cylinder_head_porting

   The graph above shows the intake runner pressure over 720 crank degrees of an engine with a 7-inch (180 mm) intake port/runner running at 4500 rpm, which is its torque peak (close to maximum cylinder filling and BMEP for this engine). The two pressure traces are taken from the valve end (blue) and the runner entrance (red).

3. Velocity stack - Wikipedia

   en.wikipedia.org/wiki/Velocity_stack

   Short velocity stacks on a 302 cu.in. Ford FE engine in the tight confines of a Ford GT-40. A velocity stack, trumpet, or air horn [1] is a typically flared, parallel-sided tubular device fitted individually or in groupings to the entry of an engine's air intake system to smooth high speed airflow, and allow engine intake track tuning to incorporate pressure pulses created by its internal ...

4. Edelbrock - Wikipedia

   en.wikipedia.org/wiki/Edelbrock

   Edelbrock has two facilities in North Carolina: the Edelbrock Carburetor Division in Sanford, and the Edelbrock Race Center in Mooresville. Vic Edelbrock founded the corporation in 1938 when his desire to increase the performance of his 1932 Ford Roadster led him to design a new intake manifold , [ 3 ] friends and fellow drivers soon wanted one ...

5. Inlet manifold - Wikipedia

   en.wikipedia.org/wiki/Inlet_manifold

   Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]

6. Weber Carburetors - Wikipedia

   en.wikipedia.org/wiki/Weber_Carburetors

   Weber pioneered the use of two-stage twin-barrel carburetors, with two venturis of different sizes (the smaller one for low-speed/rpm running and the larger one optimised for high-speed/rpm use). In the 1930s, Weber began producing twin-barrel carburetors for motor racing, where two barrels of the same size were used. These were arranged so ...

7. Heated air inlet - Wikipedia

   en.wikipedia.org/wiki/Heated_air_inlet

   A heated air inlet or warm air intake is a system commonly used on the original air cleaner assemblies of carburetted engines to increase the temperature of the air going into the engine for the purpose of improving the consistency of the air/fuel mixture to reduce engine emissions and fuel usage. [1]