enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Heat-shrink tubing - Wikipedia

   en.wikipedia.org/wiki/Heat-shrink_tubing

   Heat-shrink tubing (or, commonly, heat shrink or heatshrink) is a shrinkable plastic tube used to insulate wires, providing abrasion resistance and environmental protection for stranded and solid wire conductors, connections, joints and terminals in electrical wiring.

3. Marine grade stainless - Wikipedia

   en.wikipedia.org/wiki/Marine_grade_stainless

   Marine grade stainless alloys typically contain molybdenum to resist the corrosive effects of NaCl or salt in seawater. Concentrations of salt in seawater can vary, and splash zones can cause concentrations to increase dramatically from the spray and evaporation.

4. SAE 316L stainless steel - Wikipedia

   en.wikipedia.org/wiki/SAE_316L_stainless_steel

   SAE 316L grade stainless steel, sometimes referred to as A4 stainless steel or marine grade stainless steel, is the second most common austenitic stainless steel after 304/A2 stainless steel. Its primary alloying constituents after iron , are chromium (between 16–18%), nickel (10–12%) and molybdenum (2–3%), up to 2% manganese , [ 1 ] with ...

5. Shrink wrap - Wikipedia

   en.wikipedia.org/wiki/Shrink_wrap

   Heat-shrink tubing is used to seal electric wiring. Shrink bands are applied over parts of packages for tamper resistance or labels. It can be used as a Tamper-evident band. It can also combine two packages or parts into a Multi-pack. Shrink wrap is also commonly used within more industrial applications using a heavier weight shrink film.

6. Heat-shrink - Wikipedia

   en.wikipedia.org/wiki/Heat-shrink

   Heat-shrink may refer to: Heat-shrink tubing, for electrical work; Heat-shrinkable sleeve, for pipelines; Shrink wrap, for packaging This page was last edited on 28 ...

7. Heat-shrinkable sleeve - Wikipedia

   en.wikipedia.org/wiki/Heat-shrinkable_sleeve

   The first heat-shrinkable sleeves were introduced [when?] as polyethylene pipeline coatings started to replace bituminous or tape coatings in the oil and gas industry. At the time, the processing for polyethylene to make the sleeve backing was new technology and the adhesives used in sleeves were much the same as those used on pipeline coating.