Search results
Results from the WOW.Com Content Network
Margins also play an important role in digital word-processing and can be changed using the page setup menu. The default margins for Microsoft Word from version 2007 onward have been 1 inch (25.4 mm) all around; in Word 2003, the default top and bottom margins were 1 inch (25.4 mm), but 1.25 inches (31.7 mm) were given at the left and the right.
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
A 1:5 architectural scale (inches to feet) would be a 1:60 unitless scale (inches to inches) since there are 60 inches in 5 feet. Typical scales used in the United States are: [ 1 ] full scale, with inches, divided into sixteenths of an inch
The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]
The pica is a typographic unit of measure corresponding to approximately 1 ⁄ 6 of an inch, or from 1 ⁄ 68 to 1 ⁄ 73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
It is 5.5 typographical points, or about 1 ⁄ 13 inch (1.94 mm). It can refer either to the height of a line of type or to a font that is 5.5 points. An agate font is commonly used to display statistical data or legal notices in newspapers. It is considered to be the smallest point size that can be printed on newsprint and remain legible.
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]