enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB hub - Wikipedia

   en.wikipedia.org/wiki/USB_hub

   To allow high-speed (USB 2.0) devices to operate in their fastest mode, all hubs between the devices and the computer must be high-speed. High-speed devices should fall back to full-speed (USB 1.1) when plugged into a full-speed hub (or connected to an older full-speed computer port). While high-speed hubs can communicate at all device speeds ...

3. KVM Splitter - Wikipedia

   en.wikipedia.org/wiki/KVM_Splitter

   One PC split into 3 KVM Terminals A 2-Port VGA PS/2 KVM Splitter with 1 input and 2 outputs. A KVM (Keyboard Video Mouse) Splitter, also known as a Reverse KVM switch, is a hardware device that allows users to control a single computer from one or more sets of keyboards, video monitors, and mice. With a KVM splitter, users access the connected ...

4. KVM switch - Wikipedia

   en.wikipedia.org/wiki/KVM_switch

   High-resolution and High-refresh-rate monitors become standard setups for advanced high-end KVM switches (specially with Gaming PC). 2023: the highest resolutions and refresh-rate supported by Advanced DDM-class DisplayPort 1.4 KVM switch at 4K144hz, 5K120/240hz, 8K60hz (w/DSC) [ citation needed ]

5. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port. Because there are two separate controllers in each USB 3.0 host, USB 3.0 devices transmit and receive at USB 3.0 signaling rates regardless of USB 2.0 ...

6. Y-cable - Wikipedia

   en.wikipedia.org/wiki/Y-cable

   This is a USB 3.0 Y-cable. Traditional USB Y-cables exist to enable one USB peripheral device to receive power from two USB host sockets at once, while only transceiving data with one of those sockets. As long as the host has two available USB sockets, this enables a peripheral that requires more power than one USB port can supply (but not more ...

7. PS/2 port - Wikipedia

   en.wikipedia.org/wiki/PS/2_port

   Both PS/2 and USB allow the sample rate to be overridden, with PS/2 supporting a sampling rate of up to 200 Hz [2] and USB supporting a polling rate up to 1 kHz [11] as long as the mouse runs at full-speed USB speeds or higher, while USB 2.0 capable devices can support up to 8 kHz polling rates.