Search results
Results from the WOW.Com Content Network
For a steam ejector, the motive fluid is steam. For water-cooled surface condensers, the shell's internal vacuum is most commonly supplied by and maintained by an external steam jet ejector system. Such an ejector system uses steam as the motive fluid to remove any non-condensible gases that may be present in the surface condenser.
Steam jet cooling uses a high-pressure jet of steam to cool water or other fluid media. Typical uses include industrial sites, where a suitable steam supply already exists for other purposes or, historically, for air conditioning on passenger trains which use steam for heating. Steam jet cooling experienced a wave of popularity during the early ...
The steam which was used to turn the turbine is exhausted into the condenser and is condensed as it comes in contact with the tubes full of cool circulating water. The condensed steam, commonly referred to as condensate. is withdrawn from the bottom of the condenser. The adjacent image is a diagram of a typical surface condenser. [5] [6] [7] [8]
A condenser is designed to transfer heat from a working fluid (e.g. water in a steam power plant) to a secondary fluid or the surrounding air. The condenser relies on the efficient heat transfer that occurs during phase changes, in this case during the condensation of a vapor into a liquid. The vapor typically enters the condenser at a ...
Unlike the surface condenser often used on a steam turbine or marine steam engine, the condensing apparatus on a steam locomotive does not normally increase the power output, rather it may decrease considerably due to a reduction of airflow to the firebox that heats the steam boiler. Condensing the steam from a high volume gas to a low volume ...
Surface condenser is the most common type of condenser where it includes a water supply device. Figure 5 below displays a two-pass surface condenser. The pressure of steam at the turbine outlet is low where the steam density is very low where the flow rate is very high.
Steam leaves the boiler and reaches the condenser after passing through the main valve, regulating valves, nozzles, clearance spaces between nozzles and moving blades, diaphragm and rotating shaft, and other passages. Further, there is a large pressure difference between the inside of a steam turbine and the ambient atmosphere and also from one ...
In industrial steam systems the condensate pump is used to collect and return condensate from remote areas of the plant. The steam produced in the boiler can heat equipment and processes a considerable distance away. Once steam is used it turns to hot water or condensate.