Search results
Results from the WOW.Com Content Network
Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused. RJ11 is commonly used to connect DSL modems to the customer line.
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
RJ11 RJ14 RJ25 Twisted pair colors 25-pair colors [A] Old colors [B] German colors [C] Australian colors Dutch colors [D] Diagram 1: 3: T + T3 white/green white/green white pink orange 6P6C connector showing the location of pin 1 2: 2: T + T2: T2 white/orange white/orange black green red orange 3: 1: R: −: R1: R1: R1 blue
600 series connectors. A 600 series connector is an obsolete three-pin connector with up to six conductors.. It was for many years the standard telephone service connector in Australia, used on rural party lines and the national Postmaster-General's Department (later Telstra) landline network, but has since the 1970s been superseded by the six position modular connector in this application.
Download QR code; Print/export ... distribute and/or modify this document under the terms of the GNU Free Documentation ... An RJ11 Jack. 20:21, 30 December 2006 ...
The 6P2C, 6P4C, and 6P6C modular connectors are probably best known for their use as RJ11, RJ14, and RJ25 non-powered registered jacks, respectively (and 6P4C and 6P6C for powered RJ11 and RJ14, power being delivered on the outer pairs). These interfaces use the same six-position modular connector body but have different numbers of pins installed.
Looking at the variety of RJ11 and RJ14 telephone cables that I have for connecting from the wall socket to the actual phone, most (but not all!) seem to be wired with the pair wiring reversed from one end to the other: pins 3/4 will be red/green at one end and green/red at the other. I am assuming that ordinary telephone equipment expects this.
The new system replaced the older hard-wired system, which came in many 'flavours' (e.g., Plans 1, 1A, 1B, 1C, 2, 2A, 105, 107 etc.), which could be very complicated and required the attendance at the premises of a GPO telephone-engineer, who needed a complete set of 'N' (wiring) Diagrams, [7] [better source needed] which was very extensive and ...