enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 2.5GBASE-T and 5GBASE-T - Wikipedia

   en.wikipedia.org/wiki/2.5GBASE-T_and_5GBASE-T

   The competing MGBASE-T Alliance, stating the same faster Gigabit Ethernet objectives, was founded in December 2014. [15] In contrast to NBASE-T, the MGBASE-T said that their specifications would be open source. [16] IEEE 802.3's "2.5G/5GBASE-T Task Force" started working on the 2.5GBASE-T and 5GBASE-T standards in March 2015. [17]

3. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   Ethernet physical layer; A standard 8P8C (often called RJ45) connector used most commonly on category 5 cable, one of the types of cabling used in Ethernet networks Standard IEEE 802.3 (1983 onwards) Physical media Coaxial cable, twisted pair, optical fiber Network topology Point-to-point, star, bus Major variants

4. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.

5. IEEE 802.3 - Wikipedia

   en.wikipedia.org/wiki/IEEE_802.3

   IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of Institute of Electrical and Electronics Engineers (IEEE).

6. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...