Search results
Results from the WOW.Com Content Network
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
Accuracy is also used as a statistical measure of how well a binary classification test correctly identifies or excludes a condition. That is, the accuracy is the proportion of correct predictions (both true positives and true negatives) among the total number of cases examined. [10] As such, it compares estimates of pre- and post-test probability.
The fitted model is evaluated using “new” examples from the held-out data sets (validation and test data sets) to estimate the model’s accuracy in classifying new data. [5] To reduce the risk of issues such as over-fitting, the examples in the validation and test data sets should not be used to train the model. [5]
The hypothesis to be tested is if D is within the acceptable range of accuracy. Let L = the lower limit for accuracy and U = upper limit for accuracy. Then H 0 L ≤ D ≤ U. versus H 1 D < L or D > U. is to be tested. The operating characteristic (OC) curve is the probability that the null hypothesis is accepted when it is true.
In qualitative research, a member check, also known as informant feedback or respondent validation, is a technique used by researchers to help improve the accuracy, credibility, validity, and transferability (also known as applicability, internal validity, [1] or fittingness) of a study. [2]
Test validity is the extent to which a test (such as a chemical, physical, or scholastic test) accurately measures what it is supposed to measure.In the fields of psychological testing and educational testing, "validity refers to the degree to which evidence and theory support the interpretations of test scores entailed by proposed uses of tests". [1]
Validity [5] of an assessment is the degree to which it measures what it is supposed to measure. This is not the same as reliability, which is the extent to which a measurement gives results that are very consistent.
The definition of M&S validation focuses on the accuracy with which the M&S represents the real-world intended use(s). Determining the degree of M&S accuracy is required because all M&S are approximations of reality, and it is usually critical to determine if the degree of approximation is acceptable for the intended use(s).