enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   One particular type of reduced-shank drill bits are Silver & Deming (S&D) bits, whose sets run from 9 ⁄ 16-inch (14 mm) to 1 + 1 ⁄ 2-inch (38 mm) drill body diameter with a standard 1 ⁄ 2-inch (13 mm) reduced shank for all. This allows drill presses with 1 ⁄ 2-inch (13 mm) chucks to run the larger drills. S&D bits are 6 inches (150 mm ...

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).

4. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The Jacobs Taper (abbreviated JT) is commonly used to secure drill press chucks to an arbor. The taper angles are not consistent varying from 1.41° per side for No. 0 (and the obscure # 2 + 1 ⁄ 2) to 2.33° per side for No. 2 (and No. 2 short). There are also several sizes between No. 2 and No. 3: No. 2 short, No. 6 and No. 33.

5. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

6. Grinding wheel - Wikipedia

   en.wikipedia.org/wiki/Grinding_wheel

   Grinding wheels are self-sharpening to a small degree; for optimal use they may be dressed and trued by the use of wheel or grinding dressers. Dressing the wheel refers to removing the current layer of abrasive, so that a fresh and sharp surface is exposed to the work surface. Trueing the wheel makes the grinding surface parallel to the ...

7. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   In the U.S. it is generally for 0.25 or 0.5 inches (6.4 or 12.7 mm) bits, while in Europe bits are most commonly 6, 8 or 12 mm (0.24, 0.31 or 0.47 in). The collet nut is hexagonal on the outside so it can be tightened or loosened with a standard wrench , and has threads on the inside so it can be screwed onto the motor arbor .