Search results
Results from the WOW.Com Content Network
A flat roof is a roof which is almost level in contrast to the many types of sloped roofs. The slope of a roof is properly known as its pitch and flat roofs have up to approximately 10°. [1] Flat roofs are an ancient form mostly used in arid climates and allow the roof space to be used as a living space or a living roof. Flat roofs, or "low ...
Miami-Dade County was the first in Florida to certify hurricane-resistant standards for structures which the Florida Building Code subsequently enacted across all requirements for hurricane-resistant buildings. Many other states reference the requirements set in the Florida Building codes, or have developed their own requirements for hurricanes ...
Double-tee roof structure of an indoor swimming pool. In non-residential buildings, the roof structure may be flat. Structural concrete is an alternative for flat roof construction. There are three main categories for such method: precast/prestressed, cast-in-place and shell. Within the precast/prestressed concrete roofing, the double tees are ...
The curriculum of most public schools in the State of Florida and the FCAT are based upon this state system. [2] Development of the Sunshine State Standards began in 1993, and they were adopted by the Florida Board of Education in May 1996. The Next Generation Sunshine State Standards were approved between 2007 and 2010.
Roofing materials in Florida are chosen based on cost as well as durability. The state’s unique weather challenges can make it tricky for homeowners to balance finding the right roof type at the ...
A flat roof includes pitches as low as 1 ⁄ 2:12 to 2:12 (1 in 24 to 1 in 6), which are barely capable of properly shedding water. Such low-slope roofs (up to 4:12 (1 in 3)) require special materials and techniques to avoid leaks. [4] Conventional describes pitches from 4:12 (1 in 3) to 9:12 (3 in 4). [4]
Flat roofs actually slope up to approximately ten degrees to shed water. Flat roofs on houses are primarily found in arid regions. [2] In high-wind areas, such as where a cyclone or hurricane may make landfall, the main engineering consideration is to hold the roof down during severe storms. Every component of the roof, as of course the rest of ...
About 1913, Paraffine promoted its Malthoid roofing materials with a 16-page booklet. [15] In 1941, the Duroid Company began making Malthoid in Onehunga, New Zealand. [16] Malthoid was once common enough to be used as a generic description of flat roofing material in New Zealand and South Africa (item 26).