Search results
Results from the WOW.Com Content Network
For naval rifles, the initial change was to actual bore, thus facilitating the manufacture of standard projectiles. They then began to measure the effective length (and therefore range) of the weapon in calibers. These are a measure of the standardized length of the barrel versus the rifled bore of the barrel.
The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The term is related to the measurement of cannons, which were also measured by the weight of their iron round shot; an eight-pounder would fire an 8-pound (3.6 kg) ball. Therefore, a 12 gauge is larger than a 16 gauge. Due to problems defining a pound, and to get pure lead, the Gun Barrel Proof Act 1855 defined a gauge as a list of defined ...
This system has largely been replaced by defining the weapon in terms of the measurement of the calibre, which is the standard today for most weapon systems in use by the world's armed forces. The 18th century standards were based on a projectile's weight, which dates back to use of muzzle loaded cannons that fired solid cannonballs .
A guide to the recoil from the cartridge, and an indicator of bullet penetration potential. The .30-06 Springfield (at 2.064 lbf-s) is considered the upper limit for tolerable recoil for inexperienced rifle shooters. [2] Chg: Propellant charge, in grains; Dia: Bullet diameter, in inches; BC: Ballistic coefficient, G1 model; L: Case length (mm)
Length of pull is an important ergonomic factor for ease of use; and optimum length of pull may vary with the size of the shooter, the thickness of chest clothing and body armor being worn, [1] and whether the shooter is firing from a standing, sitting, or prone position.
The bore axis of a firearm is the longitudinal axis through the geometric center of the gun barrel. In a rifled barrel, the projectile (bullet/ball, pellet or slug) will spin around the bore axis as it goes through the barrel. Boresighting is a process of placing one's line of sight down along the bore axis.