Search results
Results from the WOW.Com Content Network
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
The pole is marked for the heights from (usually) the floor platform of a building for dimensions such as window sill heights, window top heights (or headers), exterior door heights (or headers), interior door heights, wall gas jet heights (for gas lamps) and the level of the next storey joists. It makes for quick, repeatable measurements ...
Its use in garments is growing: for example, in lining the cups of brassieres. Polyurethane is also used for moldings which include door frames, columns, balusters, window headers, pediments, medallions and rosettes. Polyurethane formulations cover an extremely wide range of stiffness, hardness, and densities. [1] These materials include:
A window sill may span the entire width of a wall from inside to outside, as is often the case in basic masonry construction, making it visible on both the interior and exterior of the building. In such a case, the exterior window sill and interior window sill would be two sides of the same structural element.
A mullioned window in the church of San Francesco of Lodi, Lombardy. A mullion is a vertical element that forms a division between units of a window or screen, or is used decoratively. [1] It is also often used as a division between double doors. When dividing adjacent window units
In the case of windows, the bottom span is referred to as a sill, but, unlike a lintel, does not serve to bear a load to ensure the integrity of the wall. Modern-day lintels may be made using prestressed concrete and are also referred to as beams in beam-and-block slabs or as ribs in rib-and-block slabs.
Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists. [1] [2] It can also refer to a jack stud that supports a header above a window or door opening. Traditionally, a stud which was less than full length was sometimes referred to as a cripple. [3] [4] [5]
This is the simplest arrangement of masonry units. If the wall is two wythes thick, one header is used to bind the two wythes together. [3] Header course: This is a course made up of a row of headers. [1] Bond course: This is a course of headers that bond the facing masonry to the backing masonry. [1] Plinth: The bottom course of a wall.