Search results
Results from the WOW.Com Content Network
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
The conversion between hydroxyl value and other hydroxyl content measurements is obtained by multiplying the hydroxyl value by the factor 17/560. [2] The chemical substance may be a fat, oil, natural or synthetic ester, or other polyol. [3] ASTM D 1957 [4] and ASTM E222-10 [5] describe several versions of this method of determining hydroxyl value.
The volume of such a mixture is slightly less than the sum of the volumes of the components. Thus, by the above definition, the term "40% alcohol by volume" refers to a mixture of 40 volume units of ethanol with enough water to make a final volume of 100 units, rather than a mixture of 40 units of ethanol with 60 units of water.
At relatively low alc/vol, the alcohol percentage by weight is about 4/5 of the alc/vol (e.g., 3.2% ABW is about 4% alc/vol). [25] However, because of the miscibility of alcohol and water, the conversion factor is not constant but rather depends upon the concentration of alcohol. [citation needed]
Stoichiometry is not only used to balance chemical equations but also used in conversions, i.e., converting from grams to moles using molar mass as the conversion factor, or from grams to milliliters using density. For example, to find the amount of NaCl (sodium chloride) in 2.00 g, one would do the following:
The degree of polymerization, or DP, is the number of monomeric units in a macromolecule or polymer or oligomer molecule. [1] [2] [3]For a homopolymer, there is only one type of monomeric unit and the number-average degree of polymerization is given by ¯ ¯ = ¯, where ¯ is the number-average molecular weight and is the molecular weight of the monomer unit.
The "hydrogen ion" and the "electron" in these examples are respectively called the "reaction units." By this definition, the number of equivalents of a given ion in a solution is equal to the number of moles of that ion multiplied by its valence. For example, consider a solution of 1 mole of NaCl and 1 mole of CaCl 2.
The usage of the pre-SI units has only historic reasons and originates directly from Antoine's original publication. It is however easy to convert the parameters to different pressure and temperature units. For switching from degrees Celsius to kelvin it is sufficient to subtract 273.15 from the C parameter.