Search results
Results from the WOW.Com Content Network
The heating value depends on the source of gas that is used and the process that is used to liquefy the gas. The range of heating value can span ±10 to 15 percent. A typical value of the higher heating value of LNG is approximately 50 MJ/kg or 21,500 BTU/lb. [2] A typical value of the lower heating value of LNG is 45 MJ/kg or 19,350 BTU/lb.
A balloon filled with gaseous hydrogen exploding.. A gas explosion is the ignition of a mixture of air and flammable gas, typically from a gas leak. [1] In household accidents, the principal explosive gases are those used for heating or cooking purposes such as natural gas, methane, propane, butane.
A flaming cocktail works by burning ethanol (grain alcohol), a type of liquid fuel also found in all alcoholic drinks. Liquid fuels are combustible or energy-generating molecules that can be harnessed to create mechanical energy, usually producing kinetic energy; they also must take the shape of their container.
If saturated LNG contacts liquid water (e.g. sea water, which has an average temperature of 15 °C), heat is transferred from the water to the LNG, rapidly vaporizing it. This results in an explosion because the volume occupied by natural gas in its gaseous form is 600 times greater than when its liquefied; this is the phenomenon of rapid phase ...
A non-combustible material [17] is a substance that does not ignite, burn, support combustion, or release flammable vapors when subject to fire or heat, in the form in which it is used and under conditions anticipated. Any solid substance complying with either of two sets of passing criteria listed in Section 8 of ASTM E 136 when the substance ...
A reaction must be capable of being initiated by the application of shock, heat, or a catalyst (in the case of some explosive chemical reactions) to a small portion of the mass of the explosive material. A material in which the first three factors exist cannot be accepted as an explosive unless the reaction can be made to occur when needed.
Tetranitrotetrahedrane explosive - computed [citation needed] 8.3: Heptanitrocubane explosive - computed [citation needed] 8.2: Sodium (reacted with chlorine) [citation needed] 7.0349: Hexanitrobenzene explosive: 7 [8] Tetranitrocubane explosive - computed [citation needed] 6.95: Ammonal (Al+NH 4 NO 3 oxidizer) [citation needed] 6.9: 12.7 ...
The time it takes for a material to reach its autoignition temperature when exposed to a heat flux ″ is given by the following equation: [4] = [″], where k = thermal conductivity, ρ = density, and c = specific heat capacity of the material of interest, is the initial temperature of the material (or the temperature of the bulk material).