enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Jerrold Electronics - Wikipedia

   en.wikipedia.org/wiki/Jerrold_Electronics

   The company was one of the earliest pioneers of community antenna television systems (cable television). The company headquarters was located at 401 Walnut Street in Philadelphia, Pennsylvania. Shapp sold the company to General Instrument in 1967. However, the Jerrold brand name continued to be used on equipment into the 1990s. [citation needed]

3. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   LNA-100 Boost Antenna Amplifier. If you’re looking for an antenna amplifier that's easy to set up and minimizes wires in your house, the Winegard LNA-100 Boost is an ideal choice.

4. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

5. List of Motorola products - Wikipedia

   en.wikipedia.org/wiki/List_of_Motorola_products

   This is a list of Motorola products. Motorola Mobility is an American subsidiary company of Chinese multinational technology company Lenovo that manufactures consumer electronics and telecommunications products.

6. Intermediate-frequency amplifier - Wikipedia

   en.wikipedia.org/wiki/Intermediate-frequency...

   Intermediate-frequency (IF) amplifiers are amplifier stages used to raise signal levels in radio and television receivers, at frequencies intermediate to the higher radio-frequency (RF) signal from the antenna and the lower (baseband) audio or video frequency that the receiver is recovering. [1]

7. Output power of an analog TV transmitter - Wikipedia

   en.wikipedia.org/wiki/Output_power_of_an_analog...

   The output power of a TV transmitter is the electric power applied to antenna system. There are two definitions: nominal (or peak) and thermal. Analogue television systems put about 70% to 90% of the transmitters power into the sync pulses. The remainder of the transmitter's power goes into transmitting the video's higher frequencies and the FM ...