Ad
related to: regenerative circuit in hydraulic system
Search results
Results from the WOW.Com Content Network
A regenerative circuit is an amplifier circuit that employs positive feedback (also known as regeneration or reaction). [ 1 ] [ 2 ] Some of the output of the amplifying device is applied back to its input to add to the input signal, increasing the amplification. [ 3 ]
A fluid power system has a pump driven by a prime mover (such as an electric motor or internal combustion engine) that converts mechanical energy into fluid energy, Pressurized fluid is controlled and directed by valves into an actuator device such as a hydraulic cylinder or pneumatic cylinder, to provide linear motion, or a hydraulic motor or pneumatic motor, to provide rotary motion or torque.
Regenerative braking has a similar energy equation to the equation for the mechanical flywheel. Regenerative braking is a two-step process involving the motor/generator and the battery. The initial kinetic energy is transformed into electrical energy by the generator and is then converted into chemical energy by the battery.
The HLA system is called a parallel hydraulic hybrid. In parallel systems the original vehicle drive-line remains, allowing the vehicle to operate normally when the HLA system is disengaged. When the HLA is engaged, energy is captured during deceleration and released during acceleration, in contrast to series hydraulic hybrid systems which ...
In electrified systems the process of regenerative braking is employed whereby the current produced during braking is fed back into the power supply system for use by other traction units, instead of being wasted as heat. It is normal practice to incorporate both regenerative and rheostatic braking in electrified systems.
Hydraulic systems are smaller and less expensive. Hydraulic fluid must be non-compressible. Unlike air brakes, where a valve is opened and air flows into the lines and brake chambers until the pressure rises sufficiently, hydraulic systems rely on a single stroke of a piston to force fluid through the system. If any vapor is introduced into the ...
Hydraulic hybrid vehicle systems consists of four main components: the working fluid, reservoir, pump/motor (in parallel hybrid system) or in-wheel motors and pumps (in series hybrid system), and accumulator. In some systems, a hydraulic transformer is also installed for converting output flow at any pressure with a very low power loss. [3]
Hydraulic systems are deceptively simple: the phenomenon of pump cavitation is a known, complex problem that few people outside of the fluid power or irrigation industries would understand. For those who do, the hydraulic analogy is amusing, as no "cavitation" equivalent exists in electrical engineering.
Ad
related to: regenerative circuit in hydraulic system