enow.com Web Search

  1. Ads

    related to: aluminum 6061 t6 fatigue curve

Search results

  1. Results from the WOW.Com Content Network
  2. 6061 aluminium alloy - Wikipedia

    en.wikipedia.org/wiki/6061_aluminium_alloy

    6061-T6 aluminium standard heat treating process. T6 temper 6061 has been treated to provide the maximum precipitation hardening (and therefore maximum yield strength) for a 6061 aluminium alloy. It has an ultimate tensile strength of at least 290 MPa (42 ksi) and yield strength of at least 240 MPa (35 ksi).

  3. Fatigue limit - Wikipedia

    en.wikipedia.org/wiki/Fatigue_limit

    The fatigue limit or endurance limit is the stress level below which an infinite number of loading cycles can be applied to a material without causing fatigue failure. [1] Some metals such as ferrous alloys and titanium alloys have a distinct limit, [ 2 ] whereas others such as aluminium and copper do not and will eventually fail even from ...

  4. Titanium alloys - Wikipedia

    en.wikipedia.org/wiki/Titanium_alloys

    contains 4.5% aluminium, 2% molybdenum, 1.6% vanadium, 0.5% iron, and 0.3% silicon. Grade 36 contains 45% niobium. Grade 37 contains 1.5% aluminium. Grade 38 contains 4% aluminium, 2.5% vanadium, and 1.5% iron. This grade was developed in the 1990s for use as an armor plating. The iron reduces the amount of Vanadium needed as a beta stabilizer.

  5. Goodman relation - Wikipedia

    en.wikipedia.org/wiki/Goodman_relation

    The general trend given by the Goodman relation is one of decreasing fatigue life with increasing mean stress for a given level of alternating stress. The relation can be plotted to determine the safe cyclic loading of a part; if the coordinate given by the mean stress and the alternating stress lies under the curve given by the relation, then ...

  6. Beryllium-aluminium alloy - Wikipedia

    en.wikipedia.org/wiki/Beryllium-aluminium_alloy

    The fatigue limit, 1 × 10 7 cycles was about 207 MPa (30 ksi) in the longitudinal direction and 165 MPa (25 ksi) in the transverse direction. This property is approximately 75% of the minimum yield strength at room temperature, which is two times that of typical fatigue properties of 6061-T6 aluminium. [citation needed]

  7. Aluminium alloy - Wikipedia

    en.wikipedia.org/wiki/Aluminium_alloy

    The temper designation follows the cast or wrought designation number with a dash, a letter, and potentially a one to three digit number, e.g. 6061-T6. The definitions for the tempers are: [5] [6]-F : As fabricated-H : Strain hardened (cold worked) with or without thermal treatment -H1 : Strain hardened without thermal treatment

  1. Ads

    related to: aluminum 6061 t6 fatigue curve