enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Category 6 cable - Wikipedia

   en.wikipedia.org/wiki/Category_6_cable

   A Cat 6 patch cable, terminated with 8P8C modular connectors. Category 6 cable (Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and ...

3. Category:Ethernet cables - Wikipedia

   en.wikipedia.org/wiki/Category:Ethernet_cables

   Pages in category "Ethernet cables" The following 12 pages are in this category, out of 12 total. This list may not reflect recent changes. C. Category 3 cable;

4. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...

5. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs).

6. Copper cable certification - Wikipedia

   en.wikipedia.org/wiki/Copper_cable_certification

   An ideal skew is between 25 and 50 nanoseconds over a 100-meter cable. The lower this skew the better; less than 25 ns is excellent, but 45 to 50 ns is marginal. (Traveling between 50% and 80% of the speed of light, an electronic wave requires between 417 and 667 ns to traverse a 100-meter cable.

7. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...