Ads
related to: 2x12 floor joist spacing
Search results
Results from the WOW.Com Content Network
Solid “bridging” to stabilize floor joists. Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking (dwang, nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
The LH- and DLH-Series have been designed for the purpose of extending the use of joists to spans and loads in excess of those covered by Open Web Steel Joists, K-Series. LH-Series Joists have been standardized in depths from 18 inches (460 mm) through 48 inches (1,200 mm), for spans through 96 feet (29,000 mm).
As of 2005, approximately 50% of all wood light framed floors used I-joists. [2] [clarification needed] I-joists were designed to help eliminate typical problems that come with using solid lumber as joists. The advantage of I-joists is they are less likely to bow, crown, twist, cup, check, or split as would a piece of dimensional lumber. I ...
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
Although close studding is defined by the distance between the vertical timbers, the spacing used is variable, up to a maximum of around 2 feet (600 mm). [2] Studs can either span the full height of the storey or be divided by a middle (or intermediate) rail. To give the frame stability, some form of diagonal bracing is required. [2]
In flooring construction, the rim joists sit on the sill plates; in deck construction, they are parallel to the support beams and sit on the beams or in some cases, cantilever away from the beams. A double thickness board in the position of a rim joist is called a flush beam and serves a dual purpose, providing primary support for the joist ...
Platform framing. In construction, a dwang Scotland and New Zealand, [1] [2] [3] nogging piece, nogging, noggin or nog (all derived from brick nog) [4] [5] England and Australia, or blocking North America, is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building.
In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers. The United States still uses imperial units of measurement and framing members are typically spaced sixteen or twenty-four inches apart.
Ads
related to: 2x12 floor joist spacing