Search results
Results from the WOW.Com Content Network
starter control 50 II 50d starter control 50b, 50k 50e starter control 50a 50f starter control 50 50g starter control 50a 50h starter control 50 Battery 15 battery+ through ignition switch 16, 54/15 30 from battery+ direct 30/51 30a from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V ...
A starter solenoid is an electromagnet which is actuated to engage the starter motor of an internal combustion engine. It is normally attached directly to the starter motor which it controls. Its primary function is as the actuating coil of a contactor (a relay designed for large electric currents) which connects the battery to the starter ...
The generator delivers current once the engine starts and part of it goes to a second Startix solenoid that switches off the current from battery to starter. If the engine and generator stop, then that second solenoid switches on the current from the battery to the starter. [3] There are many further refinements associated with the plain relay.
A system of electrical relays allowed this to be driven as a motor to rotate the engine for starting, and once the starter button was released the controlling switchgear returned the unit to operation as a generator. Because the starter-generator was directly coupled to the engine it did not need a method of engaging and disengaging the motor ...
IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter.
An electric starter with sufficient power to turn a large diesel engine would itself be so large as to be impractical so there is a need for an alternative system. An air start system has three main components along with various safety components, namely the air start injector, the distributor and the air receivers.
Alternator regulators are also simpler than those for generators. Generator regulators require a cutout relay to isolate the output coils (the armature) from the battery at low speed; that isolation is provided by the alternator rectifier diodes. Also, most generator regulators include a current limiter; alternators are inherently current-limited.
A magnetic starter has a contactor and an overload relay, which will open the control voltage to the starter coil if it detects an overload on a motor. [1] [2] The overload relay opens a set of contacts that are wired in series with the supply to the contactor feeding the motor. The characteristics of the heaters can be matched to the motor so ...