Search results
Results from the WOW.Com Content Network
A percolation test (colloquially called a perc test) is a test to determine the water absorption rate of soil (that is, its capacity for percolation) in preparation for the building of a septic drain field (leach field) or infiltration basin. [1] The results of a percolation test are required to design a septic system properly.
Owing to irregular distribution of salt in the soil or to irregularity of the soil structure (figure 2), the leaching efficiency (E L) can be different from unity. Soils with a low leaching efficiency are difficult to reclaim. In the Tagus delta, Portugal, the leaching efficiency of the dense clay soil was found as low as 0.10 to 0.15. [4]
Groundwater recharge is an important process for sustainable groundwater management, since the volume-rate abstracted from an aquifer in the long term should be less than or equal to the volume-rate that is recharged. Recharge can help move excess salts that accumulate in the root zone to deeper soil layers, or into the groundwater system.
The available volume for additional water in the soil depends on the porosity of the soil [7] and the rate at which previously infiltrated water can move away from the surface through the soil. The maximum rate at that water can enter soil in a given condition is the infiltration capacity.
Coarse soils – sand and gravel – can transmit wastewater away from the drain field before pathogens are destroyed. Silt and clay effectively filter out pathogens but limit wastewater flow rates. [3] Percolation tests measure the rate at which clean water disperses through a disposal trench into the soil.
the discharge rate (Q) from the recharge rate (R) in a water balance as detailed in the article: hydrology (agriculture) the permissible long term average depth of the water table (Dw) on the basis of agricultural drainage criteria; the soil's hydraulic conductivity (Ka and Kb) by measurements; the depth of the bottom of the aquifer (Di)
Recently completed infiltration basin for stormwater collection. An infiltration basin (or recharge basin) is a form of engineered sump [1] or percolation pond [2] that is used to manage stormwater runoff, prevent flooding and downstream erosion, and improve water quality in an adjacent river, stream, lake or bay.
Dental percolation, increase rate of decay under crowns because of a conducive environment for strep mutants and lactobacillus Potential sites for septic systems are tested by the " perc test ". Example/theory: A hole (usually 6–10 inches in diameter) is dug in the ground surface (usually 12–24" deep).