enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each of these plumbing fixtures has one or more water outlets and a drain. In some cases, the drain has a device that can be manipulated to block the drain to fill the basin of the fixture. Each fixture also has a flood rim, or level at which water will begin to overflow. Most fixtures also have an overflow, which is a conduit for water to ...

3. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

4. Floor drain - Wikipedia

   en.wikipedia.org/wiki/Floor_drain

   Floor drain system in bathroom, Korea. A floor drain is a plumbing fixture that is installed in the floor of a structure, mainly designed to remove any standing water near it. They are usually round, but can also be square or rectangular. They usually range from 2 to 12 inches (5.1 to 30.5 cm); most are 4 inches (10 cm) in diameter.

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   It is used to keep stack-vented fixtures high to the joist space and thus conserves the headroom in a basement. As the water closet must be the lowest fixture, the smaller side outlet (usually used to connect the bathtub trap arm) enters slightly above the larger connection. [citation needed]

6. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   The U-bend could not jam, so, unlike the S-bend, it did not need an overflow. In the United States, traps are commonly referred to as P-traps. It is the addition of a 90 degree fitting on the outlet side of a U-bend, thereby creating a P-like shape (oriented horizontally). It is also referred to as a sink trap because it is installed under most ...

7. Sanitary manhole - Wikipedia

   en.wikipedia.org/wiki/Sanitary_manhole

   An eccentric cone has the top opening shifted off center all the way to one side of the manhole wall. This is to allow installing permanent ladder rungs on to the manhole wall. In designing eccentric cones, the loads need to be carefully calculated as one wall is vertical wall that is aligned to the chamber wall but the opposite wall is a slope ...