enow.com Web Search

  1. Ads

    related to: stick framing vs truss

Search results

  1. Results from the WOW.Com Content Network
  2. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

  3. Stick-built construction - Wikipedia

    en.wikipedia.org/wiki/Stick-built_construction

    Stick-built homes are also built using a more traditional method of construction rather than a modular type. [2] The "sticks" mentioned usually refer specifically to the superstructure of the walls and roof. Most stick-built homes have many of the same things in common.

  4. Lumber - Wikipedia

    en.wikipedia.org/wiki/Lumber

    Manufactured trussestrusses are used in home construction as a pre-fabricated replacement for roof rafters and ceiling joists (stick-framing). It is seen as an easier installation and a better solution for supporting roofs than the use of dimensional lumber's struts and purlins as bracing.

  5. American historic carpentry - Wikipedia

    en.wikipedia.org/wiki/American_historic_carpentry

    Plank framed truss was the name for roof trusses made with planks rather than timber roof trusses. In the 20th century, it was typical for carpenters to make their own trusses by nailing planks together with wood plates at the joints. Today similar trusses are manufactured to engineering standards and use truss connector plates.

  6. Stick style - Wikipedia

    en.wikipedia.org/wiki/Stick_style

    The Stick style was a late-19th-century American architectural style, transitional between the Carpenter Gothic style of the mid-19th century, and the Queen Anne style that it had evolved into by the 1890s. [1] It is named after its use of linear "stickwork" (overlay board strips) on the outside walls to mimic an exposed half-timbered frame. [2 ...

  7. Truss and Wall-Panel Component Manufacturers Stand ... - AOL

    www.aol.com/news/2013-09-11-truss-and-wall-panel...

    Truss and Wall-Panel Component Manufacturers Stand Ready to Respond to Framing Labor Shortage NAHB Finds 48% of Single-Family Home Builders Could Not Find Framing Crews in Q1 2013, Up 30% from ...

  8. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    A simple timber frame made of straight vertical and horizontal pieces with a common rafter roof without purlins. The term box frame is not well defined and has been used for any kind of framing (with the usual exception of cruck framing). The distinction presented here is that the roof load is carried by the exterior walls.

  9. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

  1. Ads

    related to: stick framing vs truss