enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Air-line fitting - Wikipedia

   en.wikipedia.org/wiki/Air-line_fitting

   One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.

3. Swivel - Wikipedia

   en.wikipedia.org/wiki/Swivel

   In low oxygen situations and/or warm water this passivation layer breaks down and corrosion will set in. Low oxygen will occur in crevasses which stary wet (cracks, welds, shackle threads, keel bolts, etc.) or confined spaces (swivel shafts, etc.). Corrosion may also happen internally.

4. Banjo fitting - Wikipedia

   en.wikipedia.org/wiki/Banjo_fitting

   The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids damage that can be caused by twisting the hose during installation.

5. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   The "Air King" [14] universal air hose coupling, also known as a "Chicago style" fitting, is malleable iron or brass "quarter turn" "sexless coupling" usually found on large pneumatic tools like jackhammers. [6] The fitting is considered "universal", because a common two-lug head is used on all sizes ranging from 0.25 to 1 inch (6 to 25 mm).

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Fitting being crimped using a specialized tool Pressfittings connection with dead space around the O-ring. Crimped or pressed connections to use special fittings permanently attached to tubing with a powered crimper. The fittings, manufactured with a pre-installed sealant or O-ring, slide over the tubing to be connected. High pressure is used ...

7. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.