enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.

3. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   A hex key (also, hex wrench, Allen key and Allen wrench, Unbrako or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.

4. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance. This may be initially expressed on the parts drawing in a number of styles; three possibilities may be 12.75 ± 0.15 mm; 12.60 +0.30 −0.00 mm; 12.90 +0.00

5. List of ISO standards 2000–2999 - Wikipedia

   en.wikipedia.org/wiki/List_of_ISO_standards_2000...

   ISO 2490:2007 Solid (monobloc) gear hobs with tenon drive or axial keyway, 0,5 to 40 module — Nominal dimensions; ISO 2491:1974 Thin parallel keys and their corresponding keyways (Dimensions in millimetres) [Withdrawn without replacement]

6. Broaching (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Broaching_(metalworking)

   Also, there are limits on the size of internal cuts. Common internal holes can range from 0.125 to 6 in (3.2 to 152.4 mm) in diameter but it is possible to achieve a range of 0.05 to 13 in (1.3 to 330.2 mm). Surface broaches' range is usually 0.075 to 10 in (1.9 to 254.0 mm), although the feasible range is 0.02 to 20 in (0.51 to 508.00 mm).

7. Engineering drawing abbreviations and symbols - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing...

   Many corporations have such standards, which define some terms and symbols specific to them; on the national and international level, ASME standard Y14.38 [1] is one of the standards. Australia utilises the Technical Drawing standards AS1100.101 (General Principals), AS1100-201 (Mechanical Engineering Drawing) and AS1100-301 (Structural ...