enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Close studding - Wikipedia

    en.wikipedia.org/wiki/Close_studding

    Although close studding is defined by the distance between the vertical timbers, the spacing used is variable, up to a maximum of around 2 feet (600 mm). [2] Studs can either span the full height of the storey or be divided by a middle (or intermediate) rail. To give the frame stability, some form of diagonal bracing is required. [2]

  3. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

  4. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    A characteristic of the eastern school is close studding which is a half-timbering style of many studs spaced about the width of the studs apart (for example six-inch studs spaced six inches apart) until the middle of the 16th century and sometimes wider spacing after that time. Close studding was an elite style found mostly on expensive buildings.

  5. This Hack Will Ensure You ALWAYS Hit A Stud - AOL

    www.aol.com/lifestyle/hack-ensure-always-hit...

    The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.

  6. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]

  7. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    A letter v (Latin small letter v) written on a line representing a surface is a way to indicate that the surface is to be machined rather than left in the as-cast or as-forged state. The older symbol for this was a small script (italic) f (see herein f). Later the ASA convened upon a letter V (specifically a sans-serif V) touching the surface ...

  8. Load-bearing wall - Wikipedia

    en.wikipedia.org/wiki/Load-bearing_wall

    The base plate or floor plate is the bottom attachment point for the wall studs. Using a top plate and a bottom plate, a wall can be constructed while it lies on its side, allowing for end-nailing of the studs between two plates, and then the finished wall can be tipped up vertically into place atop the wall sill; this not only improves ...

  9. Wattle and daub - Wikipedia

    en.wikipedia.org/wiki/Wattle_and_daub

    A mud and stud wall in Tumby Woodside, Lincolnshire "Mud and stud" is a similar process to wattle and daub, with a simple frame consisting only of upright studs joined by cross rails at the tops and bottoms. Thin staves of ash were attached, then daubed with a mixture of mud, straw, hair and dung. The style of building was once common in ...