Search results
Results from the WOW.Com Content Network
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
81346-10 also known as RDS-PS (Reference Designation System for Power Supply Systems). [ 13 ] is maintained by ISO/IEC Joint Working Group ISO/TC10/SC10/JWG10. [ 14 ] The latest version 81346-10:2022 is published as a full International Standard, and replaces the previous Technical Specification ISO/TS 81346-10:2015.
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
NTC thermistors are widely used as inrush-current limiters and temperature sensors, while PTC thermistors are used as self-resetting overcurrent protectors and self-regulating heating elements. An operational temperature range of a thermistor is dependent on the probe type and is typically between −100 and 300 °C (−148 and 572 °F).
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
NTC thermistors can be used as inrush-current limiting devices in power supply circuits when added in series with the circuit being protected. They present a higher resistance initially, which prevents large currents from flowing at turn-on. As current continues to flow, NTC thermistors heat up, allowing higher current flow during normal operation.
For the function Measurement the reference designator B is used, followed by the above listed letter for the measured variable. For reference designation of any equipment in a power station the KKS Power Plant Classification System can be applied.
The silicon bandgap temperature sensor is an extremely common form of temperature sensor (thermometer) used in electronic equipment.Its main advantage is that it can be included in a silicon integrated circuit at very low cost.