enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   A counterbore hole is typically used when a fastener, such as a socket head cap screw or fillister head screw, is required to sit flush with or below the level of a workpiece's surface. Whereas a counterbore is a flat-bottomed enlargement of a smaller coaxial hole, a countersink is a conical enlargement of such.

3. Engineering fit - Wikipedia

   en.wikipedia.org/wiki/Engineering_fit

   Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.

4. Refrigerator - Wikipedia

   en.wikipedia.org/wiki/Refrigerator

   Food in a refrigerator with its door open. A refrigerator, commonly shortened to fridge, is a commercial and home appliance consisting of a thermally insulated compartment and a heat pump (mechanical, electronic or chemical) that transfers heat from its inside to its external environment so that its inside is cooled to a temperature below the room temperature. [1]

5. 6 Home Depot Products Under $50 That Will Reduce Your ... - AOL

   www.aol.com/finance/6-home-depot-products-under...

   But here's the good news: You don't need to spend hundreds on fancy smart thermostats or new appliances to cut... 6 Home Depot Products Under $50 That Will Reduce Your Utility Bills This Winter ...

6. Hole - Wikipedia

   en.wikipedia.org/wiki/Hole

   Hole types in engineering: blind (left), through (middle), interrupted (right). In engineering, machining, and tooling, a hole may be a blind hole or a through hole (also called a thru-hole or clearance hole). A blind hole is a hole that is reamed, drilled, or milled to a specified depth without breaking through to the other side of the ...

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.