Search results
Results from the WOW.Com Content Network
In generic terms, a stick pusher is known as a stall identification device or stall identification system. [73] A stick shaker is a mechanical device that shakes the pilot's controls to warn of the onset of stall. A stall warning is an electronic or mechanical device that sounds an audible warning as the stall speed is approached. The majority ...
On aircraft with swept wings, wing tip stall also produces an undesirable nose-up pitching moment which hampers recovery from the stall. Washout may be accomplished by other means e.g. modified aerofoil section, vortex generators, leading edge wing fences, notches, or stall strips. This is referred to as aerodynamic washout.
The effect of airfoil geometry on dynamic stall is quite intricate. As is shown in the figure, for a cambered airfoil, the lift stall is delayed and the maximum nose-down pitch moment is significantly reduced. On the other hand, the inception of stall is more abrupt for a sharp leading-edge airfoil. [8] More information is available here. [13]
A stick shaker is a mechanical device designed to rapidly and noisily vibrate the control yoke (the "stick") of an aircraft, warning the flight crew that an imminent aerodynamic stall has been detected. It is typically present on the majority of large civil jet aircraft, as well as most large military planes.
A leading-edge slot is a fixed aerodynamic feature of the wing of some aircraft to reduce the stall speed and promote good low-speed handling qualities. A leading-edge slot is a spanwise gap in each wing, allowing air to flow from below the wing to its upper surface.
Wing loading is a useful measure of the stalling speed of an aircraft. Wings generate lift owing to the motion of air around the wing. Larger wings move more air, so an aircraft with a large wing area relative to its mass (i.e., low wing loading) will have a lower stalling speed.
A stall strip is a small component fixed to the leading edge of the wing of an airplane to modify its aerodynamic characteristics. [1] These stall strips may be necessary for the airplane to comply with type certification requirements.
A wider consequence of the incident was a new design requirement related to the pilot's ability to identify and overcome stall conditions; the design of a Transport category aircraft that fails to comply with the specifics of this requirement may be acceptable if the aircraft is equipped with a stick pusher. [3] [1]