enow.com Web Search

  1. Ads

    related to: how much jitter is acceptable for voip

Search results

  1. Results from the WOW.Com Content Network
  2. Packet delay variation - Wikipedia

    en.wikipedia.org/wiki/Packet_delay_variation

    Instantaneous packet delay variation is the difference between successive packets—here RFC 3393 does specify the selection criteria—and this is usually what is loosely termed "jitter", although jitter is also sometimes the term used for the variance of the packet delay. As an example, say packets are transmitted every 20 ms.

  3. Jitter - Wikipedia

    en.wikipedia.org/wiki/Jitter

    Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]

  4. Voice over IP - Wikipedia

    en.wikipedia.org/wiki/Voice_over_IP

    The RTCP extended report VoIP metrics block specified by RFC 3611 is generated by an VoIP phone or gateway during a live call and contains information on packet loss rate, packet discard rate (because of jitter), packet loss/discard burst metrics (burst length/density, gap length/density), network delay, end system delay, signal/noise/echo ...

  5. Quality of service - Wikipedia

    en.wikipedia.org/wiki/Quality_of_service

    Commercial VoIP services are often competitive with traditional telephone service in terms of call quality even without QoS mechanisms in use on the user's connection to their ISP and the VoIP provider's connection to a different ISP. Under high load conditions, however, VoIP may degrade to cell-phone quality or worse.

  6. ITU-T - Wikipedia

    en.wikipedia.org/wiki/ITU-T

    G.114 is an ITU Recommendation that addresses acceptable delays for voice applications, is oriented to national telecommunications, and is more stringent than what is normally applied in private voice networks. One of the issues it addresses is voice delay. It states that 150 milliseconds is acceptable, while 400 milliseconds is unacceptable ...

  7. Bufferbloat - Wikipedia

    en.wikipedia.org/wiki/Bufferbloat

    Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...

  1. Ads

    related to: how much jitter is acceptable for voip