Search results
Results from the WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Standard dimension ratio (SDR) is a method of rating a pipe's durability against pressure. The standard dimension ratio describes the correlation between the pipe dimension and the thickness of the pipe wall. [1] Common nominations are SDR11, SDR17, SDR26 and SDR35. Pipes with a lower SDR can withstand higher pressures.
4.4 When pipe is cold expanded, the amount of expansion shall not exceed one and one-half percent (1-1⁄2%) of the specified outside diameter of the pipe. [4] APPLICATIONS ASTM A53 pipeline is planned for mechanical as well as pressure applications and is also appropriate for ordinary usages in vapor, water, gas and also air lines. [5]
Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16-inch (1.6 mm), so the internal diameter is only "nominal" rather than a controlling dimension. [13]
For a fully filled duct or pipe whose cross-section is a convex regular polygon, the hydraulic diameter is equivalent to the diameter of a circle inscribed within the wetted perimeter. This can be seen as follows: The N {\displaystyle N} -sided regular polygon is a union of N {\displaystyle N} triangles, each of height D / 2 {\displaystyle D/2 ...
From the mid-2000s to the early 2010s, SteelAsia expanded its reinforcing bar production capacity; from producing 279,000 tons of rebar in 2006 to 1.2 million tons in 2013, securing almost half of the rebar market share in the Philippines. [8] In 2014, it began operations of two steel mills in Mindanao, to serve the Mindanao region. [9]
During the IPS period, pipes were cast in halves and welded together, and pipe sizes referred to the inside diameters. [1] The inside diameters under IPS were roughly the same as the more modern Ductile Iron Pipe Standard (DIPS) and Nominal Pipe Size (NPS) Standards, and some of the wall thicknesses were also retained with a different ...
Standard drums have inside dimensions of 572 millimetres (22.5 in) diameter and 851 millimetres (33.5 in) height. These dimensions yield a volume of about 218.7 litres (57.8 US gal; 48.1 imp gal), but they are commonly filled to about 200 litres. Red steel drum on the frozen Lake Jyväsjärvi in Jyväskylä, Finland