enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Some woodworkers lay out their project before drilling their pocket holes and mark the face of the board that they want to drill to ensure the hole is in the correct location. Most pocket joints are made by screwing into the face or the edge of the board rather than the end grain because the screw will grab better.

3. Butt joint - Wikipedia

   en.wikipedia.org/wiki/Butt_joint

   The pocket holes require two drilling operations to be completed. The first is to counterbore the pocket hole itself, which houses the screw head within the member. This hole is stopped 1 ⁄ 4 in (6.4 mm) or so from the edge of the frame member. The second step is to drill a pilot hole concentric with the pocket hole which extends through the ...

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

5. Drill cuttings - Wikipedia

   en.wikipedia.org/wiki/Drill_cuttings

   Drill cuttings [1] are broken bits of solid material removed from a borehole drilled by rotary, percussion, or auger methods and brought to the surface in the drilling mud. Boreholes drilled in this way include oil or gas wells, water wells, and holes drilled for geotechnical investigations or mineral exploration. [2]

6. Drywall - Wikipedia

   en.wikipedia.org/wiki/Drywall

   Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

7. Drilling - Wikipedia

   en.wikipedia.org/wiki/Drilling

   For heavy feeds and comparatively deep holes oil-hole drills are used in the drill bit, with a lubricant pumped to the drill head through a small hole in the bit and flowing out along the fluting. A conventional drill press arrangement can be used in oil-hole drilling, but it is more commonly seen in automatic drilling machinery in which it is ...

8. Lath and plaster - Wikipedia

   en.wikipedia.org/wiki/Lath_and_plaster

   In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with holes spaced regularly to provide a 'key' for wet plaster. [3] Rock lath was typically produced in sheets sized 2 by 4 feet (610 by 1,220 mm).

9. Pilot hole - Wikipedia

   en.wikipedia.org/wiki/Pilot_hole

   A pilot hole may be drilled the full extent of the final hole, or may only be a portion of the final depth. The pilot drill may be a standard twist drill, another type of drill bit appropriate for the material, or, when the primary purpose is precisely locating a hole, may be made with a short, stiff center drill.