Search results
Results from the WOW.Com Content Network
After the purchase of Dodge Brothers Inc. in 1928, Chrysler Corporation had five straight-6s in production with the addition of the Victory and Senior Dodge Brothers engines. [ 1 ] So, with the introduction of the new Desoto brand in 1929, came a new and cheaper to product six cylinders, the K-Model (four main bearings, deep skirts). [ 1 ]
1978–1979: 6DR5 2.5 L 6G73 - Used in the Chrysler Sebring, Dodge Avenger, Chrysler Cirrus, and Dodge Stratus; 3.0 L 6G72 - Used in the Plymouth Acclaim/Dodge Spirit and 1987–2000 Dodge Caravan/Plymouth Voyager, also Dodge Dynasty, Chrysler LeBaron, Chrysler TC, Chrysler New Yorker, Dodge Daytona, Dodge Stealth, Chrysler Sebring (Coupe), Dodge Stratus (Coupe), Dodge Shadow ES, and Plymouth ...
The Chrysler Slant Six engine was a clean-sheet design, led by Willem Weertman, later Chrysler's chief engine designer. [1] Its characteristic 30° inclination of cylinder block gives it a lower height overall engine package. This 30° inclination had already been used by Mercedes-Benz in their 300SL sports car with the M186 engine since 1952 ...
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
A "Ram-Trac" shift-on-the-fly transfer case was added for the 1985 Power Rams, and both the crew cab and Utiline flared bed versions were discontinued for 1986, the latter not to return on any Chrysler-built pickup. In 1988, the slant-6 engine was replaced by a 3.9 L (240 cu in) fuel-injected V6 engine first introduced with the Dodge Dakota.
This was Chrysler's first thin wall (lightweight) cast iron engine design. Chrysler Australia wanted a new six-cylinder engine for use in the Australian Chrysler Valiant, and so Chrysler USA sent a prototype engine to Chrysler Australia's engineers to continue developing the D-engine. The first 245 cu in (4.0 L) variant was released for the ...
These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons. They were called Polyspheric or Poly engines, because they featured polyspherical-shaped (meaning "more than one sphere") combustion chambers. These combustion chambers were ...