Search results
Results from the WOW.Com Content Network
Ethernet physical layer; A standard 8P8C (often called RJ45) connector used most commonly on category 5 cable, one of the types of cabling used in Ethernet networks Standard IEEE 802.3 (1983 onwards) Physical media Twisted pair, optical fiber, coaxial cable Network topology Point-to-point, star, bus Major variants
Through the first half of the 1980s, Ethernet's 10BASE5 implementation used a coaxial cable 0.375 inches (9.5 mm) in diameter, later called thick Ethernet or thicknet. Its successor, 10BASE2, called thin Ethernet or thinnet, used the RG-58 coaxial cable. The emphasis was on making installation of the cable easier and less costly.
The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.
Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...
By 2001, prices for Fast Ethernet cards had fallen to under $50. By 2003, Wi-Fi networking equipment was widely available and affordable. Due to the immense demand for high-speed networking, the low cost of Category 5 cable , and the popularity of 802.11 wireless networks, both 10BASE2 and 10BASE5 have become increasingly obsolete , though ...
The Attachment Unit Interface (AUI) is a physical and logical interface defined in the IEEE 802.3 standard for 10BASE5 Ethernet [1] and the earlier DIX standard. The physical interface consists of a 15-pin D-subminiature connector that links an Ethernet node's physical signaling to the Medium Attachment Unit (MAU), [2] sometimes referred to as ...
The same field is also used to indicate the size of some Ethernet frames. EtherType is also used as the basis of 802.1Q VLAN tagging, encapsulating packets from VLANs for transmission multiplexed with other VLAN traffic over an Ethernet trunk. EtherType was first defined by the Ethernet II framing standard and later adapted for the IEEE 802.3 ...
Ethernet Virtual Private LAN (EVP-LAN) is a multipoint-to-multipoint Ethernet Virtual Connection defined by the MEF — a Carrier Ethernet equivalent of Virtual Private LAN Service (VPLS) or Transparent LAN Services. EVP-LAN enables any-to-any communication between all customer locations associated with the customer's Ethernet Virtual ...