Search results
Results from the WOW.Com Content Network
Sideslip causes one main landing gear to touch down first, followed by the second main gear. This allows the wheels to be constantly aligned with the track, thus avoiding any side load at touchdown. The sideslip method for crosswind landings is not suitable for long-winged and low-sitting aircraft such as gliders , where instead a crab angle ...
The landing gear represents 2.5 to 5% of the maximum takeoff weight (MTOW) and 1.5 to 1.75% of the aircraft cost, but 20% of the airframe direct maintenance cost. A suitably-designed wheel can support 30 t (66,000 lb), tolerate a ground speed of 300 km/h and roll a distance of 500,000 km (310,000 mi) ; it has a 20,000 hours time between overhaul and a 60,000 hours or 20 year life time.
Conventional landing gear, or tailwheel-type landing gear, is an aircraft undercarriage consisting of two main wheels forward of the center of gravity and a small wheel or skid to support the tail. [ 1 ] [ 2 ] The term taildragger is also used.
English: Landing gear of an aircraft, schematic view of the retracting mechanism. Filled circles are fixed relative to the airframe. Coloured arcs denote the locus of points. 1 Hydraulic Ram 2 Hinge Mechanism 3 Strut 4 Wheel Boss 5 Wheel . 6 Fuselage/Wing
Some aircraft use lift spoilers on landing approach to control descent without changing the aircraft's attitude. One jet airliner not fitted with lift spoilers was the Douglas DC-8 which used reverse thrust in flight on the two inboard engines to control descent speed (however the aircraft was fitted with lift dumpers).
Pages in category "Aircraft with retractable conventional landing gear" The following 200 pages are in this category, out of approximately 535 total. This list may not reflect recent changes .
Intentionally putting an aircraft into a slip is used as a forward slip and a sideslip. These slips are performed by applying opposite inputs of the aileron and rudder controls. A forward slip allows a pilot to quickly drop altitude without gaining unnecessary speed, while a sideslip is one method utilized to perform a crosswind landing.
Aircraft tires generally operate at high pressures, up to 200 psi (14 bar; 1,400 kPa) for airliners, [2] and even higher for business jets [citation needed].The main landing gear on the Concorde was typically inflated to 232 psi (16.0 bar), whilst its tail bumper gear tires were as high as 294 psi (20.3 bar). [3]