Search results
Results from the WOW.Com Content Network
DOS-based systems make the logical parallel ports detected by the BIOS available under device names such as LPT1, LPT2 or LPT3 (corresponding with logical parallel port 1, 2, and 3, respectively). These names derive from terms like Line Print Terminal , Local Print Terminal (both abbreviated as LPT ), or Line Printer.
The most common usage is the DB25, using TASCAM's pinout (now standardised in AES59 by the Audio Engineering Society [1]). To avoid the possibility of bent pins on fixed equipment, the male connector is generally fitted to the cabling and the female connector to the equipment.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
Because personal computers first used DB-25 connectors for their serial and parallel ports, when the PC serial port began to use 9-pin connectors, they were often labeled as DB-9 instead of DE-9 connectors, due to an ignorance of the fact that B represented a shell size. It is now common to see DE-9 connectors sold as DB-9 connectors.
A copy of the license is included in the section entitled GNU Free Documentation License. This file is licensed under the Creative Commons Attribution-Share Alike 3.0 Unported , 2.5 Generic , 2.0 Generic and 1.0 Generic license.
For Wide SCSI-2, the most common connector was the larger 68-pin sibling of the HD50, known as the HD68, MiniD68, HPDB68, and sometimes as "SCSI-3". This is about 1 7/8” (47mm) wide. [ 3 ] IBM used the HDCN68 on some RS-6000 systems, and it seems likely that a few other manufacturers used other alternatives.
Currently known as TIA-530-A, but often called EIA-530, or RS-530, is a balanced serial interface standard that generally uses a 25-pin connector, originally created by the Telecommunications Industry Association. Finalized in 1987 (revision A finalized in 1992 [1]), the specification defines the cable between the DTE and DCE devices.