Search results
Results from the WOW.Com Content Network
Also in North America, hardwood lumber is commonly sold in a "quarter" system, when referring to thickness; 4/4 (four quarter) refers to a 1-inch-thick (25 mm) board, 8/4 (eight quarter) is a 2-inch-thick (51 mm) board, etc.
The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist .
In the metric system, the mass per unit area of all types of paper and paperboard is expressed in terms of grams per square metre (g/m 2).This quantity is commonly called grammage in both English and French, [2] though printers in most English-speaking countries still refer to the "weight" of paper.
Caliper/thickness: In the United States caliper is usually expressed in thousandths of an inch (0.001”) or points, where a sheet of paperboard with a thickness of 0.024” would be 24 points. In Europe it is often sold in g/m 2 , however the thickness of the board is measured in micron (μm).
When used as siding boards, widths between 130mm and 300mm (5.25 inch to 12 inch) are available. [4] Fiber cement thicknesses vary between 4.5-18mm and also vary in density – the lower density resulting in a fibrous rough edge when cut and the higher density having a cleaner smoother edge when cut.
Visualization with paper sizes in formats A0 to A8, exhibited at the science museum CosmoCaixa Barcelona An A4 paper sheet folded into two A5 size pages. ISO 216 is an international standard for paper sizes, used around the world except in North America and parts of Latin America.
The pressing cycle operates in stages, with the mat thickness being first compressed to around 1.5 times the finished board thickness, then compressed further in stages and held for a short period. This gives a board profile with zones of increased density, thus mechanical strength, near the two faces of the board and a less dense core. [9]
Top of a copper clad Perfboard with solder pads for each hole. Perfboard is a material for prototyping electronic circuits.It is a thin, rigid sheet with holes pre-drilled at standard intervals across a grid, usually a square grid of 0.1 inches (2.54 mm) spacing.