Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
direct TPM sensor fitted in valve system, manufacturer VDO. In most current designs of direct TPMS, a small electronic assembly which is rugged enough to be mounted inside a tire, measures the pressure using a microelectromechanical system (MEMS) [1] pressure sensor and then transmits this and other information to one or more vehicle receivers. [1]
After the calibration pulse, each nibble is transmitted with a fixed-width low signal, followed by a variable-length high period. The low pulse-width is 5 (or more) ticks in length, while the high pulse-width can vary, for a total period between falling edges of between 12-27 ticks (representing nibbles ranging from 0-15).
The protocol communicates at 160 baud with Pulse-width modulation (PWM) signaling and monitors all engine management functions. It reports real-time sensor data, component overrides, and Diagnostic Trouble Codes. The specification for this link is as defined by GM's Emissions Control System Project Center document XDE-5024B. [4] [5]
This is commonly referred to as gauge pressure. Boost pressure is relative to absolute pressure - as one increases or decreases, so does the other. It is a one-to-one relationship with an offset of -100 kPa for boost pressure. Thus, a MAP sensor will always read 100 kPa more than a boost sensor measuring the same conditions.
The sensor has an input port to measure the hydraulic braking pressure and an electrical connector output for a wire connection for feeding the warning light. Some brake failures do not trip the sensor into a fault mode. A brake fluid pressure sensor is used in anti-lock braking system (ABS). ABS fault lights come on with unexpected wheel lock ...
Ford's internal code name for the TLCS-12 microprocessor was "PM-11" or "Poor Man's 11" implying it was a stripped down version of the, then popular, Digital Equipment Corporation PDP-11 computer. A PDP-11 was used in a vehicle in the first half of the 1970s for "proof of concept".
Peripheral Sensor Interface (PSI5) is a digital interface for sensors. PSI5 is a two-wire interface, used to connect peripheral sensors to electronic control units in automotive electronics . Both point-to-point and bus configurations with asynchronous and synchronous data transmission are supported.