Search results
Results from the WOW.Com Content Network
Pace [6] in minutes per kilometre or mile vs. slope angle resulting from Naismith's rule [7] for basal speeds of 5 and 4 km / h. [n 1]The original Naismith's rule from 1892 says that one should allow one hour per three miles on the map and an additional hour per 2000 feet of ascent.
Elevation or altitude is generally expressed as "metres above mean sea level" in the metric system, or "feet above mean sea level" in United States customary and imperial units. Common abbreviations in English are: AMSL – above mean sea level [3] ASL – above sea level [4] FAMSL – feet above mean sea level [5] FASL – feet above sea level [6]
For instance the same angle of 0.1 mrad will subtend 10 mm at 100 meters, 20 mm at 200 meters, etc., or similarly 0.39 inches at 100 m, 0.78 inches at 200 m, etc. Subtensions in mrad based optics are particularly useful together with target sizes and shooting distances in metric units .
A cable's length (often "cable length" or just "cable") is simply the standard length in which cables came, which by 1555 had settled to around 100 fathoms (600 ft; 180 m) or 1 ⁄ 10 nautical mile (0.19 km; 0.12 mi). [1] Traditionally rope is made on long ropewalks, the length of which determines the maximum length of rope it is possible to make.
A nautical mile is a unit of length used in air, marine, and space navigation, and for the definition of territorial waters. [2] [3] [4] Historically, it was defined as the meridian arc length corresponding to one minute ( 1 / 60 of a degree) of latitude at the equator, so that Earth's polar circumference is very near to 21,600 nautical miles (that is 60 minutes × 360 degrees).
Therefore, a pressure altitude of 32,000 ft (9,800 m) is referred to as "flight level 320". In metre altitudes the format is Flight Level xx000 metres. Flight levels are usually designated in writing as FLxxx , where xxx is a two- or three-digit number indicating the pressure altitude in units of 100 feet (30 m).
Interactive maps, databases and real-time graphics from The Huffington Post
The FCC procedure to calculate HAAT is: from the proposed or actual antenna site, either 12 or 16 radials were drawn, and points at 2, 4, 6, 8, and 10 miles (16 km) radius along each radial were used. The entire radial graph could be rotated to achieve the best effect for the station.