Search results
Results from the WOW.Com Content Network
The millimetre (SI symbol: mm) is a unit of length in the metric system equal to 10 −3 metres ( 1 / 1 000 m = 0.001 m). To help compare different orders of magnitude , this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm).
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
In 1930, the British Standards Institution adopted an inch of exactly 25.4 mm. The American Standards Association followed suit in 1933. By 1935, industry in 16 countries had adopted the "industrial inch" as it came to be known, [35] [36] effectively endorsing Johansson's pragmatic choice of conversion ratio. [32]
The French National Print Office adopted a point of 2 ⁄ 5 mm or 0.400 mm in about 1810 and continues to use this measurement today (though "recalibrated" to 0.398 77 mm). [ 21 ] [ 22 ] [ 23 ] Japanese [ 24 ] and German [ 9 ] [ 16 ] [ 18 ] standardization bodies instead opted for a metric typographic base measure of exactly 1 ⁄ 4 mm or 0.250 ...
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
Different lengths as in respect to the electromagnetic spectrum, measured by the metre and its derived scales.The microwave is between 1 meter to 1 millimeter.. The millimetre (international spelling; SI unit symbol mm) or millimeter (American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length.
There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart. It was used in some early transistor radio amplifiers with a Class B output stage, allowing the loud speaker to be connected between the amplifier output and the battery center tap.
The Reagan administration made Letter-size paper the norm for US federal forms in the early 1980s; previously, the smaller "official" Government Letter size, 8 by 10.5 inches (203.2 by 266.7 mm) (aspect ratio: 1.3125), was used in government, while 8.5-by-11-inch (215.9 by 279.4 mm) paper was standard in most other offices. [2]