Search results
Results from the WOW.Com Content Network
Using the figures above, we can calculate the maximum pressure at various depths in an offshore oil well. Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal)
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
An imperial fluid ounce is 1 ⁄ 20 of an imperial pint, 1 ⁄ 160 of an imperial gallon or exactly 28.4130625 mL. A US customary fluid ounce is 1 ⁄ 16 of a US liquid pint and 1 ⁄ 128 of a US liquid gallon or exactly 29.5735295625 mL, making it about 4.08% larger than the imperial fluid ounce. A US food labeling fluid ounce is exactly 30 mL.
The corn gallon, or Winchester gallon, of about 268.8 cubic inches (≈ 4.405 L), The wine gallon, or Queen Anne's gallon, which was 231 cubic inches [54] (≈ 3.785 L), and; The ale gallon of 282 cubic inches (≈ 4.622 L). The corn or dry gallon is used
The area required to calculate the volumetric flow rate is real or imaginary, flat or curved, either as a cross-sectional area or a surface. The vector area is a combination of the magnitude of the area through which the volume passes through, A , and a unit vector normal to the area, n ^ {\displaystyle {\hat {\mathbf {n} }}} .
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
The metric equivalent flow factor (K v) is calculated using metric units: =, where [3]. K v is the flow factor (expressed in m 3 /h), Q is the flowrate (expressed in m 3 /h), SG is the specific gravity of the fluid (for water = 1),
[3] [5] Use of the gal was deprecated by the standard ISO 80000-3:2006, now superseded. The gal is a derived unit, defined in terms of the centimeter–gram–second (CGS) base unit of length, the centimeter, and the second, which is the base unit of time in both the CGS and the modern SI system. In SI base units, 1 Gal is equal to 0.01 m/s 2.