Search results
Results from the WOW.Com Content Network
Example: if a rat in a Skinner box gets food when it presses a lever, its rate of pressing will go up. Pressing the lever was positively reinforced. Pressing the lever was positively reinforced. Negative reinforcement (a.k.a. escape) occurs when a behavior (response) is followed by the removal of an aversive stimulus, thereby increasing the ...
In computing, an operand is the part of a computer instruction which specifies what data is to be manipulated or operated on, while at the same time representing the data itself. [5] A computer instruction describes an operation such as add or multiply X, while the operand (or operands, as there can be more than one) specify on which X to ...
The number of operands is one of the factors that may give an indication about the performance of the instruction set. A three-operand architecture (2-in, 1-out) will allow A := B + C to be computed in one instruction ADD B, C, A A two-operand architecture (1-in, 1-in-and-out) will allow A := A + B to be computed in one instruction ADD B, A
Separate from the stack definition of a MISC architecture, is the MISC architecture being defined by the number of instructions supported. Typically a minimal instruction set computer is viewed as having 32 or fewer instructions, [1] [2] [3] where NOP, RESET, and CPUID type instructions are usually not counted by consensus due to their fundamental nature.
Example: A situation in which multiple instructions are ready to enter the execute instruction phase and there is a single ALU (Arithmetic Logic Unit). One solution to such resource hazard is to increase available resources, such as having multiple ports into main memory and multiple ALU (Arithmetic Logic Unit) units.
Instructions included an address for the operand. For instance, an ADD address instruction would cause the CPU to retrieve the number in memory found at that address and then add it to the value already in the accumulator. This very simple example ISA has a "one-address format" because each instruction includes the address of the data. [4]
Corner quotes, also called “Quine quotes”; for quasi-quotation, i.e. quoting specific context of unspecified (“variable”) expressions; [4] also used for denoting Gödel number; [5] for example “āGā” denotes the Gödel number of G. (Typographical note: although the quotes appears as a “pair” in unicode (231C and 231D), they ...
The operator precedence is a number (from high to low or vice versa) that defines which operator takes an operand that is surrounded by two operators of different precedence (or priority). Multiplication normally has higher precedence than addition, [1] for example, so 3+4×5 = 3+(4×5) ≠ (3+4)×5.