Search results
Results from the WOW.Com Content Network
Benchtop drill press (left) and floor-standing drill press (right) A drill press is a drilling machine suitable for quick and easy drilling of straight holes, countersinking or counterboring that are perpendicular to both directions of a table surface. In comparison, it is more difficult and less repeatable to drill perpendicularly with a hand ...
Tracking and recording of drill pipe at the rig site starts when individual joints are picked up. Joint numbers are manually marked on the side of the pipe. Typically three sections of pipe are joined into a stand (of about 27–29 m in length) and stacked in rows of 10, with their base resting on the drill floor. Prior to running in the hole ...
Slips is a device used to grip and hold the upper part of a drill string to the drill floor on an oil rig. [1] The slips are constructed as a collection of metal wedges, hinged together to form a circular shape around the drill pipe. On the inside surface, the slips normally has replaceable steel teeth that grips the pipe.
A drill press Drill press (then called a boring machine) boring wooden reels for winding barbed wire, 1917. A drill press (also known as a pedestal drill, pillar drill, or bench drill) is a style of drill that may be mounted on a stand or bolted to the floor or workbench. Portable models are made, some including a magnetic base.
[2] [3] [4] A punch press is used to form holes. A screw press is also known as a fly press. A stamping press is a machine press used to shape or cut metal by deforming it with a die. It generally consists of a press frame, a bolster plate, and a ram. [5] Capping presses form caps from rolls of aluminium foil at up to 660 per minute.
There are several kinds of underbalanced drilling. The most common are listed below. Dry air. This is also known as dusting. Here air compressors combined with a booster (which takes the head from the compressors and increases the pressure of the air, but does not increase the volume of air going down hole) are used and the only fluid injected into the well is a small amount of oil to reduce ...
Machine tapers for tool holding included Morse tapers (on early models) and the R8 taper (a widely used standard that Bridgeport created) on most models. Both Morse and R8 allowed for both collets and solid holders, and a drill chuck could be held by either of the latter. Currently R8 and Erickson #30 Quick Change tool holders are available.
Twist drill bits range in diameter from 0.002 to 3.5 in (0.051 to 88.900 mm) [9] and can be as long as 25.5 in (650 mm). [10] The geometry and sharpening of the cutting edges is crucial to the performance of the bit. Small bits that become blunt are often discarded because sharpening them correctly is difficult and they are cheap to replace.