Search results
Results from the WOW.Com Content Network
An architect's scale is a specialized ruler designed to facilitate the drafting and measuring of architectural drawings, such as floor plans and Multi-view orthographic projections. Because the scale of such drawings is often smaller than life-size, an architect's scale features multiple units of length and proportional length increments. [1]
Examples include a 3-dimensional scale model of a building or the scale drawings of the elevations or plans of a building. [1] In such cases the scale is dimensionless and exact throughout the model or drawing. The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale.
The drawing was made 130 years after the bridge was built. A linear scale, also called a bar scale, scale bar, graphic scale, or graphical scale, is a means of visually showing the scale of a map, nautical chart, engineering drawing, or architectural drawing. A scale bar is common element of map layouts.
The foreshortening factor (1/2 in this example) is inversely proportional to the tangent of the angle (63.43° in this example) between the projection plane (colored brown) and the projection lines (dotted). Front view of the same. Oblique projection is a type of parallel projection: it projects an image by intersecting parallel rays (projectors)
Plans are usually "scale drawings", meaning that the plans are drawn at specific ratio relative to the actual size of the place or object. Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ...
Mathematics in art: Albrecht Dürer's copper plate engraving Melencolia I, 1514. Mathematical references include a compass for geometry, a magic square and a truncated rhombohedron, while measurement is indicated by the scales and hourglass. [1] Wireframe drawing [2] of a vase as a solid of revolution [2] by Paolo Uccello. 15th century
For example, in Finland the series used is 1.8 mm, 2.5 mm, 3.5 mm, 5.0 mm and 7.0 mm. Except for the very biggest ones, the templates are only suitable for technical pen drawing. For drawing circles and circle-arcs, circle templates which contain a set of suitably-sized holes are used.
First-angle is drawing the object sides based on where they land. Example, looking at the front side, rotate the object 90 degrees to the right. What is seen will be drawn to the right of the front side. Third-angle is drawing the object sides based on where they are. Example, looking at the front side, rotate the object 90 degrees to the right.