Search results
Results from the WOW.Com Content Network
First Tile Cutter Invented by Boada Brothers. The ceramic tile cutter works by first scratching a straight line across the surface of the tile with a hardened metal wheel and then applying pressure directly below the line and on each side of the line on top. Snapping pressure varies widely, some mass-produced models exerting over 750 kg.
Gilding is a decorative technique for applying a very thin coating of gold over solid surfaces such as metal (most common), wood, porcelain, or stone. [1] A gilded object is also described as "gilt". Where metal is gilded, the metal below was traditionally silver in the West, to make silver-gilt (or vermeil ) objects, but gilt-bronze is ...
A three-dimensional edge-matching puzzle is a type of edge-matching puzzle or tiling puzzle involving tiling a three-dimensional area with (typically regular) polygonal pieces whose edges are distinguished with colors or patterns, in such a way that the edges of adjacent pieces match.
The shingle edges are then cut with another circular saw called a "trim saw" to remove irregular edges. The result is a tapered shingle sawn on all six sides. The thickness of the butt, or thicker end of the tapered cut, is usually 3 ⁄ 8 inch (9.5 mm) thick but is also commonly made to be 5 ⁄ 8 inch (16 mm), and can be made to any custom ...
Edge enhancement is an image processing filter that enhances the edge contrast of an image or video in an attempt to improve its acutance (apparent sharpness).. The filter works by identifying sharp edge boundaries in the image, such as the edge between a subject and a background of a contrasting color, and increasing the image contrast in the area immediately around the edge.
Initially modern dropped ceilings were built using interlocking tiles and the only way to provide access for repair or inspection of the area above the tiles was by starting at the edge of the ceiling, or at a designated "key tile", and then removing contiguous tiles one at a time until the desired place of access was reached.
To quantify a cutting edge the following parameters are used: cutting edge radius for symmetric edges; cutting edge ellipse axis for asymmetric edges; factor K, this is the relation between Sγ and Sα. This can also be calculated by the ratio of the two axis of the ellipse. This factor describes the form of the cutting edge.
Cutting-edge tech has also been applied to marquetry. Among these is laser cutting , where the design is drawn or imported as a CAD or vector file and each piece is cut separately; each different species of wood-and thickness-may need a specific adjustment of the beam power; the offset will determine the gap between the pieces.