Search results
Results from the WOW.Com Content Network
The mechanical component of MEP is an important superset of HVAC services. Thus, it incorporates the control of environmental factors (psychrometrics), either for human comfort or for the operation of machines. Heating, cooling, ventilation and exhaustion are all key areas to consider in the mechanical planning of a building. [4]
These drawings are often a set of detailed drawings used for construction projects; it is a requirement for all HVAC work. They are based on the floor and reflected ceiling plans of the architect. After the mechanical drawings are complete, they become part of the construction drawings, which is then used to apply for a building permit.
A plumbing drawing, a type of technical drawing, shows the system of piping for fresh water going into the building and waste going out, both solid and liquid. It also includes fuel gas drawings. Mainly plumbing drawing consist of water supply system drawings, drainage system drawings, irrigation system drawings, storm water system drawings.
A list, usually tabular and often on the drawing (if not accompanying the drawing on a separate sheet), listing the parts needed in an assembly, including subparts, standard parts, and hardware. There is no consistently enforced distinction between an L/M, a BoM, or a P/L. PLM: product lifecycle management; plant lifecycle management: See also ...
ISO Standards Handbook – Technical drawings, a broad collection of all basic ISO drawing standards Vol.1 Technical drawings in general, ISBN 92-67-10370-9; Vol.2 Mechanical engineering drawings, construction drawings, drawing equipment, ISBN 92-67-10371-7; ISO 128 Technical drawings—General principles of presentation
ISO 128-44:2001 Technical drawings — General principles of presentation — Part 44: Sections on mechanical engineering drawings ISO 128-50:2001 Technical drawings — General principles of presentation — Part 50: Basic conventions for representing areas on cuts and sections
The process of producing engineering drawings is often referred to as technical drawing or drafting (draughting). [1] Drawings typically contain multiple views of a component, although additional scratch views may be added of details for further explanation.
Shop drawings are produced by contractors and suppliers under their contract with the owner. The shop drawing is the manufacturer’s or the contractor’s drawn version of information shown in the construction documents. [1] The shop drawing normally shows more detail than the construction documents.