Search results
Results from the WOW.Com Content Network
The edge crush test is a laboratory test method that is used to measure the cross-direction crushing of a sample of corrugated board.It gives information on the ability of a particular board construction to resist crushing.
For example, with rubber, tear resistance measures how the test specimen resists the growth of any cuts when under tension, it is usually expressed in kN/m. [2] Tear resistance can be gauged via the same ASTM D 412 apparatus used to measure tensile strength, modulus and elongation.
Hazardous chemicals present physical and/or health threats to workers in clinical, industrial, and academic laboratories. Laboratory chemicals include cancer-causing agents (carcinogens), toxins (e.g., those affecting the liver, kidney, and nervous system), irritants, corrosives, sensitizers, as well as agents that act on the blood system or damage the lungs, skin, eyes, or mucous membranes.
The usual safety standard for a level floor is a minimum Pendulum Test Value (PTV) of 36. The pendulum is also the instrument used in the Sustainable Slip Resistance test method, which measures the possible impact of years of use on a potential flooring's slip resistance.
In Sweden, it is in kilograms-force (kgf), and in Australia, either in newtons (N) or kilonewtons (kN). This confusion is greatest when the results are treated as units, for example "660 Janka". [4] The Janka hardness test results tabulated below followed ASTM D 1037-12 testing methods. Lumber stocks tested range from 1" to 2" (25–50 mm) thick.
Compact tension specimens are used for experiments where there is a shortage of material available due to their compact design. For rolled materials the notch should be aligned with the roll direction where the material is weakest. This will allow the user to ensure that all results achieved are conservative (worst-case scenario).
The test method consists of pushing an instrumented cone, with the tip facing down, into the ground at a controlled rate (controlled between 1.5 -2.5 cm/s accepted). The resolution of the CPT in delineating stratigraphic layers is related to the size of the cone tip, with typical cone tips having a cross-sectional area of either 10 or 15 cm 2 ...
When a test fails to meet the thickness and other test requirements that are in place to ensure plane strain conditions, the fracture toughness value produced is given the designation . Fracture toughness is a quantitative way of expressing a material's resistance to crack propagation and standard values for a given material are generally ...