Search results
Results from the WOW.Com Content Network
f/2.8: ISO speed rating: 500: Date and time of data generation: 10:16, 8 July 2018: Lens focal length: 31 mm: Latitude: 40° 50′ 0.87″ N: Longitude: 73° 25′ 15.33″ W: Orientation: Normal: Horizontal resolution: 300 dpi: Vertical resolution: 300 dpi: Software used: Adobe Photoshop CS6 (Windows) File change date and time: 22:19, 10 ...
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
With a finished weight of 36 pounds (16 kg), the block weighs 51 pounds (23 kg) less than the cast-iron block in the Chevy II 153 cu in (2.5 L) inline-4. Plating the piston skirts was necessary to put a hard iron skirt surface opposite the silicon of the block to prevent scuffing. The plating was a four layer electro-plating process.
The engine was intended to be used for big passenger cars and trucks; [2] it was installed in such (with minor, incremental changes) [3] until 1953, making the engine's 21-year production run for the U.S. consumer market longer than the 19-year run of the Ford Model T engine. [3] It was also built independently by Ford licensees. [citation needed].
Compared to the FB20 engine, which is undersquare with an 84 mm × 90 mm (3.31 in × 3.54 in) bore and stroke for 2.0 L (1,995 cc) swept displacement, the FA20 is perfectly square with an 86 mm × 86 mm (3.39 in × 3.39 in) bore and stroke for 2.0 L (1,998 cc) swept displacement.
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
The Holden straight-six motor is a series of straight-six engines that were produced by General Motors Holden at their Port Melbourne plant between 1948 and 1986. The initial Grey motor was so dubbed because of the colour of the cylinder block, later motors came in the form of a Red, Blue, Black, and the four-cylinder Starfire engine.
Development for the new car began in 1968 to be powered by a new all-aluminum die-cast engine block technology. The first sand-cast aluminum blocks had preceded the decision to build the car by two years. It was a relatively large displacement engine with good low-speed torque, with gear ratios for low engine rpm to achieve fuel economy. Engine ...